Axmin UE-153DV1, Руководство по эксплуатации, Страница: 10 / 18

- 8 -
Auto Cutting
Feed Rate by spring holding
Turn toggle switch to lower location. (Fig. 7)
Select spring as outer location. (Lower photo
Fig.8) Press green button down (Fig. 5) to start
auto cutting.
Fig.7
Fig.8
Manual Cutting
Feed Rate by Handle with Trigger
Switch
Turn toggle switch to upper location. (Fig. 7)
Select spring as inner location. Screw in from
outer to inner location for 50mm (upper photo
Fig. 8)
Push down the trigger switch in for cutting
material by handle. (Fig. 9)
Fig. 9
Angle Cutting
The machine uses a swivel miter base for angle
cutting from 0~60 degree. On the sawing arm,
there is an attached angle scale (Q) in Fig.10.
This machine is preset zero degree before
leaving the factory. Angle cutting is adjusted as
follows.
1. Loosen handle (R) Fig.10 to release the
arm.
2. Move this swivel arm forward along the
scale to search a right index for the work to
be cut.
3. If the pointer matches the right index on the
scale. Tighten the handle, and a perfect
angle cut will be given.
Fig. 10
WARNING
Disconnect machine from the power source!
No matter when, where, or how. Pay extra
attention to the saw during it in transportation,
operation, and maintenance. Or adjustment.
Failure to comply may cause serious injury!
R
Q
Trigger switch
Toggle switch
Screw in
50mm
For manual cutting
For auto cutting