Axis T92A20, Руководство по установке

Страница: 9 / 11

AXIS T92A20 Installation Guide Page 9
ENG
LISH
Route the cables to the housing
The following instructions describe the installation of the housing on the bracket:
1. Route the cables from the bracket through the holes on the underside of the housing.
2. Secure AXIS T92A20 to the wall bracket using the supplied wall bracket screws.
3. Connect the network cable to the PWR IN/POE IN connector on the High PoE Splitter (fig.3).
4. If applicable, connect the I/O cables to the camera connectors as described in the installation
guide supplied with the camera.
Connect power to the housing
Warning!
Please observe relevant national and local regulations for the installation.
1. Connect the network cable to the AXIS T812 3 High PoE Midspan. See Installation Guide for
AXIS T812 3 High PoE Midspan for details.
Complete the installation
1. Check that all cables and wires in the housing are properly connected.
2. Connect the AC mains power cable to the AXIS T812
3 High PoE Midspan and check that the
LEDs on the camera light up according to the description in the Installation Guide.
3. Follow the instructions in the Installation Guide to install the camera on the network.
4. Once the installation is complete and the camera focus has been set, close the lid and tighten
the screws to lock the housing using the supplied hexagonal key.
5. The installation is now complete.
Note:
The Axis network camera installation guide is shipped with the camera or available from the Axis
web site at www.axis.com
5
6
7