Axis Q8665-LE PTZ, Руководство по установке

Страница: 37 / 228

AXIS Q8665–LE PTZ Network Camera
Reset to Factory Default Settings
Important
Reset to factory default should be used with caution. A reset to factory default will reset
all settings, including the IP address, to the factory default values.
Note
The installation and management software tools are available on the CD supplied with the
product and from the support pages on
www.axis.com/techsup
To reset the product to the factory default settings:
1. Disconnect power from the product.
2. Press and hold the control button and reconnect power. See
Hardware Overview on
page 11 .
3. Keep the control button pressed for about 15–30 seconds until the status LED indicator
flashes amber.
4. Release the control button. The process is complete when the status LED indicator turns
green. The product has been reset to the factory default settings. If no DHCP server is
available on the network, the default IP address is
192.168.0.90
5. Using the installation and management software tools, assign an IP address, set the
password, and access the video stream.
It is also possible to reset parameters to factory default via the web interface. Go to Setup
> System Options > Maintenance .
Change the Fuse in the Light Sensor Box
DANGER
Risk of electric shock. Disconnect power supply to the equipment prior to working inside
panel.
CAUTION
• The electrical connections and conduit installations shall be made by a certified electrician
and in compliance with local regulations.
• Risk of fire. For continued protection against risk of fire, the fuses must be replaced
with the same type and rating.
1. Disconnect the power supply.
2. Open the lid to the light sensor box by removing the screws.
3. Check the fuse by using a multimeter.
- If the fuse is intact, continue to Change the Fuses in the Base Unit on page 38 .
37
E
N
G
L
IS
H