Axis Q6055-C, Руководство по установке

Страница: 11 / 156

AXIS Q6055-C PTZ Dome Network Camera
How to install the product
Read all the instructions before installing the product. Some installation steps would benefit from
being completed together because they require removal of the dome cover.
NO NO NOTICE TICE TICE
• Due to local regulations or the environmental and electrical conditions in which the
product is to be used, a shielded network cable (STP) may be appropriate or required.
All cables connecting the product to the network and that are routed outdoors or in
demanding electrical environments shall be intended for their specific use. Make sure that
the network devices are installed in accordance with the manufacturer’s instructions. For
information about regulatory requirements, see
Regulatory information on page 4 .
• Mount the product with the dome cover facing downward.
• The product has a dehumidifying membrane for maintaining low humidity levels inside the
dome. To avoid condensation, do not disassemble the product in rain or damp conditions.
• Be careful not to scratch, damage or leave fingerprints on the dome cover because this
could decrease image quality. If possible, keep the protective plastic on the dome cover
until the installation is complete.
The product can be mounted with the cables routed through or along the wall or roof.
Recommended tools
• Wire stripping tool (cable connecting)
• Philips screwdriver PH2 (dome replacement)
• Torx® screwdriver T20 (cleaning of the outer heat sink when necessary)
• Torx® screwdriver T30 (dome cover removal, bracket adapter AXIS T91A, dome
replacement)
• Diagonal pliers (cables)
How to replace the dome cover (optional)
The premounted clear dome cover can be replaced if you want to use a smoked dome cover or if the
dome cover is scratched or damaged. Smoked dome covers and spare clear dome covers can be
purchased from your Axis reseller.
1. Loosen the dome ring screws and remove the dome cover.
2. Remove the dome bracket screws and remove the dome bracket and the dome cover
from the dome ring.
3. Make sure the rubber gasket is fitted correctly on the dome cover.
4. Align the bulge on the dome cover with one of the logotypes on the dome ring.
5. Attach the dome bracket and the dome cover to the dome ring and tighten the screws
(torque 1.2 Nm).
11
EN