Page 8
Axis Thermal Camera Accessories and Spare Parts Installation Guide
Replace the lens
The instructions below describe how to replace the camera lens.
For information on available lens
options, go to www.axis.com or contact your Axis reseller.
Outdoor cameras
1. Remove the top cover.
2. Disconnect the window heater cable from the window heater connector on the camera.
3. Refer to the instructions in
Indoor/outdoor cameras
, below.
Indoor/outdoor cameras
1. Disconnect the network cable.
2. Loosen the stop screw.
3. Unscrew the lens by turning it counter-clockwise.
Note:
Make sure the wave bracket behind the lens stays in place.
4. Install the replacement lens by turning it clockwise.
5. Connect the network cable.
6. Open the Live View page of the network camera and go to
Setup > System Options >
Advanced > Plain config
.
7. Select
ImageSource
in the drop-down list and click
Select group
.
8. Select the matching lens option in the
ImageSource IO Lens
drop-down list.
9. Focus the camera to the appropriate distance. See the table below for recommended focus
distances for achieving optimal focus both for near focus and infinity.
10. Secure the stop screw.
Notes:
• Hold the lens gently by the metal ring; do not touch the lens surface.
• Be careful not to get dust on the sensor while exchanging the lens.
Lens
10 mm
19 mm
35 mm
60 mm
Focus distance
2 m (6.6 ft.)
8 m (26.2 ft.)
22 m (72.2 ft.)
60 m (196.9 ft.)
Wave bracket
Stop screw
