Axis P5544 PTZ, Руководство по установке

Страница: 13 / 100

AXIS P5544 Installation Guide Page 13
EN
GLIS
H
Install an SD Card (not included)
Installing a standard or high capacity SD card (not included), which can be used for local recording
with removable storage, is optional.
1. Loosen the 4 top cover screws and remove the top cover, see illustration on page 7.
2. Insert an SD card (not included) into the SD card slot.
3. Put the top cover back in its original position and fasten the screws cross-wise (torque 2.0 -
2.5 Nm).
To prevent corruption of recordings, the SD card should be unmounted before it is ejected.
To unmount, go to
Setup > System Options > Storage > SD Card
and click
Unmount
.
After remounting, the alignment of the lens may differ slightly and the PTZ mechanics
should be recalibrated. Go to
Basic Setup
or
System Options > Maintenance
and click
Cal-
ibrate PTZ
. For more information, see the User Manual available at www.axis.com
Hard ceiling mount
1. Prepare the ceiling for installation of the mounting plate, use the supplied drill template to
position the holes. Make sure to use drill bits, screws, and plugs that are appropriate for the
material.
2. Install the mounting plate.
3. Loosen the 4 camera base lid screws and remove the camera base lid, see illustration on page 7.
4. Route and connect the network cable and the multi-connector cable, if applicable, to the
network camera. Be careful not to damage the cables when connecting them. Make sure the
foam gasket holes are aligned with the cable tracks and, if applicable, remove the cut-out piece
for the multi-connector cable from the foam gasket.
5. Put the camera base lid back in its original position and fasten the screws.
6. Secure the camera using the supplied safety wire.
Mounting plate
Security wire