Axis P5534 Outdoor T95A00 Kit, Руководство по установке, Страница: 25 / 28

AXIS P5534 Outdoor T95A Kit Page 25
EN
GLIS
H
Resetting to the Factory Default Settings
To reset the camera to the original factory default settings, use the control button and reset button
on the side of the camera (see page 16) as described below. This will reset all parameters, including
the IP address, to the factory default settings.
1. Remove the fastening ring, dome cover and rubber gasket, see Prepare for installation , on page
7.
2. Press and hold the control and restart buttons at the same time.
3. Release the restart button but continue to hold down the control button.
4. Continue to hold down the control button until the Status indicator color changes to amber
(this may take up to 15 seconds).
5. Release the control button.
6. When the Status indicator changes to green (which may take up to 1 minute), the process is
complete and the camera has been reset. The unit now has the default IP address 192.168.0.90
7. Replace the fastening ring, dome cover and rubber gasket.
8. Re-assign the IP address, using one of the methods described in
Assign an IP address , on page
18.
It is also possible to reset parameters to the original factory default settings via the web interface.
For more information, please see the online help or the User’s Manual available from the AXIS
Network video Product CD supplied with this product.
Accessing the camera from the Internet
Once installed, your network camera is accessible on your local network (LAN). To access the
camera from the Internet, network routers must be configured to allow incoming traffic, which is
usually done on a specific port.
• HTTP port (default port 80) for viewing and configuration
• RTSP port (default port 554) for viewing H.264 video streams
Please refer to the documentation for your router for further instructions. For more information on
this and other topics, visit the Axis Support Web at www.axis.com/techsup
Further information
The User’s Manual is available from the Axis Web site at www.axis.com or from the Axis Network
Video Product CD supplied with this product.
Tip!
Visit www.axis.com/techsup to check if there is updated firmware available for your
network camera. To see the currently installed firmware version, see
Setup
>
About
.