Before you begin
The outdoor antenna can be installed either on a mast
or wall. It is recommended that the outdoor antenna is
always installed in clear line of sight and at the same
height as the access point’s antenna. It is also
recommended that an outdoor access point is used,
since even a window can reduce performace.
Notes:
• It is strongly recommended that you use a lightning arrester
when installing the outdoor antenna to protect your network.
5500-321 ACC LIGHTNING PROTECTOR 211W
• Do not operate the outdoor antenna when closer than 0.2m to a
person.
Unpacking
In the box you will find the outdoor
antenna with pole mounting bracket
and one antenna cable.
56 mm
11mm
6 mm
30 mm
Wall mount
1. Remove U-bolts from bracket by
loosening and removing nuts.
2. Attach bracket with antenna to
the wall with four screws (not
included) suited for wall material.
3. Follow instructions for attaching
antenna cable.
Mast mount
Place antenna with bracket over
mast and tighten nuts until the
bracket is secure. Follow
instructions for attaching antenna
cable.
Attach antenna cable
1. Remove plastic cap from
antenna and attach the male
connector to the antenna.
2. Thread antenna into
housing. Depending on the
type of housing this could be
through a gland or an
internal cable channel. Refer
to the installation guide for
your housing.
3. Remove plastic cap from the
antenna connector of the
AXIS 211W.
4. Attach the female end of the cable to antenna
connector.
5. Close the housing.
Specifications
Electrical
Frequency
2400 - 2500 MHz
Gain
6 dBi typical
Polarization
Vertical
Elevation 3dB beam
width
20
°
typical
Azimuth beam width
360
°
Impedance
50
Ω
nominal
VSWR
1.5 max.
Mechanical
Length (incl. connector) 456 mm
Connector
N-Type Female
Radome material
Fiberglass
Mounting
5 cm (2”) maximum diameter
mast with U-bolts
Weight
≤
350 g (0.77 lbs)
Environmental Conditions
Operating temperature
-40 to 70
°
C (-40 to 158
°
F)
Maximum survival wind
speed
240 kph (150 mph)
Water Proof
IPX5
Typical range
300 m (in a clear line of sight)
Cable
Length
3 m
Connectors
• Reverse SMA
• N-plug