Axis M7016, Руководство по установке

Страница: 14 / 88

AXIS M7016 Video Encoder
Function Pin Notes
RS485/RS422 RX/TX
A
1
RS485/RS422 RX/TX
B
2
(RX) For full duplex RS485/RS422
(RX/TX) For half duplex RS485
RS485/RS422 TX A
3
RS485/RS422 TX B
4
(TX) For full duplex RS485/RS422
Install the Hardware
How to mount the video encoder
The unit can be mounted in a rack or on a wall.
1. Remove the existing four screws on the supplied mounting bracket.
2. Attach the mounting brackets to the video encoder at an angle suitable for installation
in a standard 1U 19” rack or on the wall, see page 14 .
How to mount the video encoder on a wall
1. Position the video encoder against the wall with the brackets attached, and mark the
four mounting holes, two for each bracket.
2. Drill the four mounting holes.
3. Attach the video encoder to the wall using appropriate screws.
Connect the cables
1. Connect the video encoder to the network using a network cable RJ45.
2. Connect the cameras to the video inputs.
3. Connect the supplied indoor power adapter.
4. Check that the indicator LEDs indicate the correct conditions. See
LED Indicators on
page 11
NO NO NOTICE TICE TICE
Make sure the unit is properly grounded by using the grounding screw.
If the unit will be used with cameras or accessories located outdoors then its ground screw
should be connected to a local grounding point.
14