12
USER MANUAL
_____________________________________________________________________________________________________________________
8.
Preparation to work
1.
Take the scale out of the package and remove protective foils.
2.
Hang the scale in the way which exclude mounting’s break or load’s fall down (mounting should
hold at least 200% of maximum load).
Improper mounting of the scale can be dangerous for Your life or health.
3.
If the battery is discharged, plug the feeder plug to a connector on a right side of a panel, plug a
feeder to the mains (~230V). Charging should last at least 3 hours. It is possible to use the scale
while the battery is charging.
9.
Balance checking and adjustment
It is advised to check scale indication accuracy before and after series of measurement using any load with
known weight.
To check the scale with legal verification use a calibration weight with valid calibration certificate. In case
permissible error is exceeded it is advised to contact the nearest service to calibrate the scale.
Adjusting (calibration) scale should be made if the scale precision is not sufficient. A standard of mass should be
used with Max value taken from scale technical data table. In case of legalized scales with inaccessible
calibration (secure seal) contact with service is recommended.
10.
Accumulator change
1.
Remove screws
11
and
hold plate
12
, remove the plate.
Take out container with
accumulators
13
and place 4 AA
format accumulators. The way of
packing accumulators into the
container is shown on the figure on
the left and is also shown on the
container.
12
11
13
