18
Installation and wiring
Do not attempt to install or service the player yourself. Installation and servicing require
experience in electronic equipment and automotive accessories. If you do not have the
knowledge or experience this installation may be dangerous and could expose you to the
risk of electric shock or other hazards.
Read these instructions and precautions carefully. Improper installation can damage the
monitor and the vehicle.
What is included in the box
In addition to this manual, the box contains:
z
1 Player
z
1 IR remote control with battery
z
1 Audio/Video RCA cable
z
5
CM 4 x
13
/
5
ST 4.2 x
25.4
/
6 T
B
3
x
8 /13 KB 2.6 x 6
Screws
z
1 Metal mounting plate
z
1 Plastic ring
Note:
Use only the contents of this package to install and use the system. Using accessories
not provided with this player may cause damage.
Before you begin
1. Verify that the vehicle electrical components function, including power windows, power
door locks, air conditioning, lights, etc.
2. Identify the polarity of the dome light circuit and set the switch on the bottom of the
overhead monitor housing.
3. Test fit the location of the overhead monitor system to ensure it will not interfere with the
operation of the vehicle.
4. If applicable, verify that the monitor, when mounted, will not interfere with the operation of
the sun roof.
5. Carefully mark the location with masking tape.
6. Lower the vehicle’s h
eadliner down to see if a roof support beam is available to screw the
mounting bracket to.
If a support beam is not available, use a 3/4-inch piece of plywood cut to the appropriate
size. Attach the plywood to the roof of the vehicle using silicone. Allow for adequate
drying time.
7. Determine the location of any additional audio/video sources.
8. Disconnect the negative battery terminal before making any wiring connections.