Axis 14363, Руководство пользователя

Страница: 62 / 95

Section 6: Download/Upload
58 AXIS AFP IOP User’s Manual
When the Interface has been set into upgrade mode in the [Remote Setup]
menu (fig. 8), it will start searching for a serial signal (fig 9). Note that the
host session is determined when setup mode is activated. The host session
will not be established again until the next Power ON.
Figure 9.
The desired download or upload should now be selected by the utility
program menus [Download] or [Upload]. The COM port and baudrate
should have been set prior to this operation in the utility program [Setup]
menu under [Ouput]. The baud rate is by default set to 19200 which
most PC's should be able to run. However, most modern PC's can handle
baud rates up to 57600. This value of course gives the fastest download.
Figure 10.
When the Download or the Upload operation is activated the interface
will establish the link and display the detected baudrate (fig. 10). If
communications problems occur during download and upload then check
that the PC and the Printer use a common ground (not through the serial
cable). If not, then connect the devices to a common ground or select a
baudrate of 19200 or lower.
Remote Setup
Remote Master.
Looking for
Ready Return
Remote Setup.
At 57600 Baud.
Link established
Ready Return