AXIOMTEK MPC175-873 Series, Руководство пользователя

Страница: 4 / 91

iv
Safety Precautions
Before getting started, read the following important safety precautions.
1. The MPC175-873 Series does not come equipped with an operating system. An
operating system must be loaded first before installing any software into the
computer.
2. Be sure to ground yourself to prevent static charge when installing the internal
components. Use a grounding wrist strap and place all electronic components in any
static-shielded devices. Most electronic components are sensitive to static electrical
charge.
3. Disconnect the power cord from the MPC175-873 Series before any installation. Be
sure both the system and external devices are turned OFF. A sudden surge of power
could ruin sensitive components that the
MPC175-873 Series must be properly
grounded.
4. Make sure it is the correct voltage of the power source before connecting the
equipment to the power outlet.
5. The brightness of the flat panel display will be getting weaker as a result of frequent
usage. However, the operating period varies depending on the application
environment.
6. Turn OFF the system power before cleaning. Clean the system using a cloth only. Do
not spray any liquid cleaner directly onto the screen. The
MPC175-873 Series may
come with or w/o a touchscreen. Although the touchscreen is chemical resistant, it is
recommended that you spray the liquid cleaner on a cloth first before wiping the
screen. In case your system comes without the touchscreen, you must follow the
same procedure and not spray any cleaner on the flat panel directly.
7. Avoid using sharp objects to operate the touchscreen. Scratches on the touchscreen
may cause malfunction or internal failure to the touchscreen.
8. The flat panel display is not susceptible to shock or vibration. When assembling the
MPC175-873 Series , make sure it is securely installed.
9. Do not leave this equipment in an uncontrolled environment where the storage
temperature is below -20
℃
or above 60
℃
. It may damage the equipment.
10. External equipment intended for connection to signal input/out or other connectors
shall comply with relevant UL/IEC standard.
11.
Do not open the system’s back cover. If opening the cover for maintenance is a must,
only a trained technician is allowed to do so. Integrated circuits on computer boards
are sensitive to static electricity. To avoid damaging chips from electrostatic
discharge, observe the following precautions:

Before handling a board or integrated circuit, touch an unpainted portion of the
system unit chassis for a few seconds. This will help to discharge any static
electricity on your body.

When handling boards and components, wear a wrist-grounding strap,
available from most electronic component stores.
Classification
1.
Degree of production against electric shock: not classified
2. Degree of protection against the ingress of water: IPX1
3. Equipment not suitable for use in the presence of a flammable anesthetic mixture
with air or with oxygen or nitrous oxide.
4. Mode of operation: Continuous
5. Type of protection against electric shock: Class I equipment