AXIOMTEK IMB700, Руководство пользователя

Страница: 15 / 74

IMB700 LGA4189 ATX Motherboard
Board and Pin Assignments 9
2.4.1 Temperature Sensor Source Select (JP2)
Use these jumpers (3x1-pin p=2.54mm) to set temperature sensor source to operate
from an external sensor or in onboard mode.
Note
An external sensor can be installed at 1-2.
2.4.2 PCIe x16 slot bifurcation (JP13)
Use these jumpers (3x1-pin p=2.54mm) to set signal for slot location 5 and 6 used as
PCIe x16 slot.
Note
If the setting is 1-2 close, slot location 6 is for PCIe x16 signal and slot
location 5 has no signal.
If the setting is 2-3 close, slot location 6 is PCIe x8 signal and slot location
5 is PCIe x8.
2.4.3 Clear CMOS (JP19)
This jumper (3x1-pin p=2.54mm) allows you to clear the Real Time Clock (RTC) RAM in
CMOS. You can clear the CMOS memory of date, time, and system setup parameters
by erasing the CMOS RTC RAM data. The onboard button cell battery powers the RAM
data in CMOS, which includes system setup information such as system passwords.
To erase the RTC RAM:
1.
Turn OFF the computer and unplug the power cord.
2.
Remove the onboard battery.
3.
Move the jumper clip from pins 1-2 (default) to pins 2-3. Keep the clip on pins 2-3
for about 5~10 seconds, then move the clip back to pins 1-2.
4.
Re-install the battery.
5.
Plug the power cord and turn ON the computer.
6.
Hold down the <Del> key during the boot process and enter BIOS setup to re-enter
data.
Function Setting
External Sensor (CN5) 1-2 close
Onboard Sensor (Default) 2-3 close
Function Setting
X16 and no signal (Default) 1-2 close
X8 and X8 2-3 close
Function Setting
Normal operation (Default) 1-2 close
Clear CMOS 2-3 close