AXIOMTEK eBOX710-521-FL Series, Руководство пользователя

Страница: 71 / 77

eBOX710-521-FL Series u
ser’s Manual
Configuring SATA for RAID
63
APPENDIX C
CONFIGURING SATA FOR RAID
C.1 Configuring SATA Hard Drive(s) for RAID
(Controller: Intel
®
C246)
Before you begin the SATA configuration, please prepare:
 Two SATA hard drives (to ensure optimal performance, it is recommended that you use
two hard drives with identical model and capacity). If you do not want to create RAID with
the SATA controller, you may prepare only one hard drive.
Please follow up the steps below to configure SATA hard drive(s):
1.
Install SATA hard drive(s) in your system.
2.
Enter the BIOS Setup to configure SATA controller mode and boot sequence.
3.
Configure RAID by the RAID BIOS.
1. Installing SATA hard drive(s) in your system.
Connect one end of the SATA signal cable to the rear of the SATA hard drive, and the other
end to available SATA port(s) on the board. Then, connect the power connector of power
supply to the hard drive.
2. Configuring SATA controller mode and boot sequence by the BIOS Setup.
You have to make sure whether the SATA controller is configured correctly by system BIOS
Setup and set up BIOS boot sequence for the SATA hard drive(s).