Axiom QS8 v4, Руководство пользователя

Страница: 6 / 8

Front Left Speaker: White
Subwoofer: Purple
(line-level RCA output only)
Front Right: Red
Center: Green
Left Surround (side): Blue
Right Surround (side): Gray
Left Back Surround: Brown
Right Back Surround: Tan
Hookup
Turn the speakers around and look at the back
panel. You’ll see gold-plated 5-way binding posts,
to which you are going to connect the speaker
cables from your receiver or amplifier. Each gold
binding post is colour coded. RED is POSITIVE,
BLACK is NEGATIVE. You will also see a
positive (+) sign engraved in the plastic beneath
the RED binding post, and a negative (-) sign
beneath the BLACK post. Your amplifier will
likely have these same colours and/or symbols.
Note: for surround and center channels the
positive is likely a different colour on your receiver
or amplifier. However, black is universally used
for the negative (-).
Examine your speaker cables. There will be
something to differentiate each wire in the pair
of wires; the insulation may have color coding,
or one wire may be copper-colored while the
other is silver-coloured, or there may be printing
on one of the wires, or a ribbed pattern on the
plastic insulation of one of the wires. IT IS
EXTREMELY IMPORTANT TO CHOOSE
ONE WIRE TYPE TO BE THE NEGATIVE
AND FOLLOW THAT THROUGH YOUR
ENTIRE HOOKUP.
The Axiom binding post is very versatile to suit
the type of wire end you may be desirous to use
(see wiring diagram). If you are using spade
connectors the ¼” type is best as the Axiom
binding post will lock in a ¼” spade to stop it
from spinning when tightened by lifting the ring
on the post under the nut. BE SURE TO USE
THE SUPPLIED PLASTIC WRENCH TO
TIGHTEN YOUR BINDING POSTS AND
CHECK THEM EVERY YEAR TO ENSURE
THEY ARE STILL TIGHT.
Step 2
Leave washer down.
Step 1
Bare ends of speaker wire.
Step 3
Insert bare end of
wire through exposed
hole on binding post.
Ensure positive wire
from Amp is in red
connector.
Step 4
Tighten nuts with sup-
plied plastic wrench.
Step 1
Lift washer.
Step 2
Ensure positive wire
from Amp is in red
connector.
Step 1
Tighten nuts with
supplied
plastic wrench
Step 3
Insert banana plug .
Step 3
Tighten nuts with sup-
plied plastic wrench.
Spade Lug (1/4-inch spade)
Bare Wire
Banana Plug (3/4-inch spacing)
Step 2
Insert spade into slots
in binding post.
Ensure positive wire
from Amp is in red
connector.