3603 Burron Avenue, Saskatoon, SK S7P 0E4 Ph: (306) 651-1815
email: [email protected] website: www.axiomind.com
Permanently Removing the Check Valve
In the event that you find it necessary to remove the check valve permanently (outlet discharge
tubing passes through an area where freezing may occur), use a 7/32” drill bit on the inlet side of
the check valve to remove the ball and spring. Only insert drill bit half way through check valve.
See figure 1 below.
Figure 1:
To remove ball and spring from bottom of check valve use 7/32” drill bit
NOTE - See maintenance section for check valve removal from pump (page 6, item 2).
7/32” drill bit
Inlet
outlet
3
