Front Left Speaker: White
Subwoofer: Purple
(line-level RCA output only)
Front Right: Red
Center: Green
Left Surround (side): Blue
Right Surround (side): Gray
Left Back Surround: Brown
Right Back Surround: Tan
Hookup
Turn the speakers around and look
at the back panel. You’ll see gold-
plated 5-way binding posts, to which
you are going to connect the speaker
cables from your receiver or amplifier.
Each gold binding post is colour
coded. RED is POSITIVE, BLACK
is NEGATIVE. You will also see
a positive (+) sign engraved in the
plastic beneath the RED binding
post, and a negative (-) sign beneath
the BLACK post. Your amplifier will
likely have these same colours and/
or symbols. Note: for surround and
centre channels the positive is likely
a different colour on your receiver or
amplifier. However, black is universally
used for the negative (-).
Examine your speaker cables. There
will be something to differentiate
each wire in the pair of wires; the
insulation may have color coding,
or one wire may be copper-colored
while the other is silver-coloured, or
there may be printing on one of the
wires, or a ribbed pattern on the plastic
insulation of one of the wires. IT IS
EXTREMELY IMPORTANT TO
CHOOSE ONE WIRE TYPE TO BE
THE NEGATIVE AND FOLLOW
THAT THROUGH YOUR ENTIRE
HOOKUP.
The Axiom binding post is very
versatile to suit the type of wire end
you may be desirous to use (see wiring
diagram). If you are using spade
connectors the ¼” type is best as the
Axiom binding post will lock in a ¼”
spade to stop it from spinning when
tightened by lifting the ring on the
post under the nut. BE SURE TO
USE THE SUPPLIED PLASTIC
WRENCH TO TIGHTEN YOUR
BINDING POSTS AND CHECK
THEM EVERY YEAR TO ENSURE
THEY ARE STILL TIGHT.
For detailed instructions on dual binding post inputs please visit
www.axiomaudio.com/dual-input-connections
Step 2
Leave washer down.
Step 1
Bare ends of speaker wire.
Step 3
Insert bare end of wire
through exposed hole
on binding post. Ensure
postive wire from Amp is
in red connector.
Step 4
Tighten nuts with supplied
plastic wrench.
Step 1
Lift washer.
Step 2
Ensure positive wire from
Amp is in red connector.
Step 1
Tighten nuts with supplied
plastic wrench
Step 3
Insert banana plug
.
Step 3
Tighten nuts with supplied
plastic wrench.
Spade Lug (1/4-inch spade)
Bare Wire
Banana Plug (3/4-inch spacing)
Step 2
Insert spade into slots in
binding post.
Ensure positive wire from
Amp is in red connector.
Содержание M5HP v4
Страница 1: ...M5HP v4 Bookshelf ...