Axiom LFR660 v4, Руководство пользователя, Страница: 4 / 6

Front Left Speaker: White
Subwoofer: Purple
(line-level RCA output only)
Front Right: Red
Center: Green
Left Surround (side): Blue
Right Surround (side): Gray
Left Back Surround: Brown
Right Back Surround: Tan
Hookup
Turn your speakers around and look at
the back panel. You’ll see two sets of gold-
plated 5-way binding posts, to which you
are going to connect the speaker cables
from your amplifi er. Each gold binding
post is color coded - RED is POSITIVE,
BLACK is NEGATIVE. You will also see
a positive (+) sign engraved in the plastic
beneath the RED binding post, and a
negative (-) sign beneath the BLACK post.
It is important that the negative wires from
your amplifi er go to the negative inputs on
your speaker and the positive wires from
your amplifi er go to the positive inputs
on your speaker. Th
e top set of binding
posts are for the speakers in the rear of
the LFR660. Th
ese should be connected
to your amplifi er on the same channel as
OUT REAR on your DSP. Th
e lower set
of binding posts are for the speakers in
the front of the LFR660. Th
ese should be
connected to your amplifi er on the same
channel as OUT FRONT on your DSP.
If you purchased the bi-amp/bi-wire
option the front speaker section your
bott om input will have two sets of 5-way
binding posts. Th
e top set is always the
high frequency and the lower set the low
frequency. Th
ese two sets of binding posts
are connected with bridging bars which
are required if you are only using one amp
and one speaker cable. To utilize the bi-
amp or bi-wire feature be sure to remove
these bridging bars.
Leveling
To level your speaker simply rotate the
outside of each foot until they reach the
desired height.
For detailed instructions on dual binding post inputs please visit
www.axiomaudio.com/dual-input-connections
Step 2
Leave washer down.
Step 1
Bare ends of
speaker wire.
Step 3
Insert bare end of wire
through exposed hole
on binding post. Ensure
positive wire from Amp is
in red connector.
Step 4
Tighten nuts with supplied
plastic wrench.
Step 1
Lift washer.
Step 2
Ensure positive wire from
Amp is in red connector.
Step 1
Tighten nuts with
supplied plastic wrench
Step 3
Insert banana plug .
Step 3
Tighten nuts with supplied
plastic wrench.
Spade Lug (1/4-inch spade)
Bare Wire
Banana Plug (3/4-inch spacing)
Step 2
Insert spade into slots in
binding post.
Ensure positive wire from
Amp is in red connector.