5
Setting Up Your HR100 for Use
Displaying your Heart Rate
Heart rate is displayed in the Heart Rate/Time of Day main
screen (refer to Fig 4). From any main screen, press the
Select button until you reach that screen. Within a few sec-
onds, provided that you are wearing the transmitter chest
belt, the upper display will show your heart rate and a flash-
ing heart icon. Below your heart rate, Time of Day will also
be displayed.
A long period of inactivity (with no heart rate signals and
no button presses for two minutes) will cause the receiver
to switch off automatically. When the receiver switches off,
the Time of Day with Date main screen will be displayed.
Note: Even when the receiver is deactivated, the transmitter
will continue to send a signal when it is worn. To conserve
transmitter battery power, the transmitter belt should be
removed when not in use.
Setting the Time of Day and Date
Please refer to Fig. 4.
Note: At any point during Set Up, the Return button
brings you back to the previous screen while a long press
of the Return button will take you back to the main
screen and out of Set Up mode.
1. When in the Time of Day with Date main screen, a short
press of the Adjust button will show you if the unit is in 12
or 24 hour mode. A long press of the Adjust button will
change the current hour mode to the other one. In the 12
hour mode, the “PM” icon will appear with the time between
noon and midnight.
2.Press and hold the Select button to enter the time set-up
screen. The seconds will flash. Press the Adjust button to
zero the seconds.
3. Press the Select button again to set the hours. The hours
will flash. Press the Adjust button to advance the hours.
Holding the Adjust button causes the hours to increase
rapidly.
4. Press the Select button again to set the minutes. The
minutes will flash. Press the Adjust button to advance the
minutes. Holding the Adjust button causes the minutes to
increase rapidly.
5. Press the Select button again to set the month, and set
the correct month using the Adjust button.
6. Press the Select button again to set the day, and set the
day of the month using the Adjust button.
4
Figure 3. Full HR100 logic diagram
Axiom HRM100 Instr 3/29/99 5:37 PM Page 4
