TELESTO Set-Up Guide
page 9 / 9
Reference : FDE-3108164-A
CLEANING YOUR PRINTER
Depending on the environment in which the printer is used, it can accumulate dust. Therefore it is necessary
to clean it periodically to maintain a good print quality. The cleaning period depends on the environment and
the usage of the printer, but the printhead should be cleaned at least once a year, and up to one month in case
of heavy duty applications.
Cleaning
Instructions:
Unplug the printer.
Never clean the head immediately after printing, the head may be hot.
Open the cover, clean the heating dots line of the head with a cotton stick containing a solvent
alcohol (ethanol, methanol, or IPA) but
do not touch the printhead with your fingers
!
Allow the solvent to dry and close the cover.
N.B : AXIOHM can also provide cleaning kits with the instructions to use it. The kit reference is
CK80000A.
GENERAL INFORMATION
•
Power Supply:
UL Listed power supply with SELV (Secondary Extra Low Voltage) non energy hazard output,
limited energy source input rated 100-240 Vac, 2.0 A, 50/60 Hz, output rated 24 Vdc, 4.3 A for 75
watt unit.
Product characteristics are guaranteed with Axiohm power supply reference 3108213
•
Communication Interface Cable:
A shielded interface cable must be used with this product. The shield must be connected to the frame
or earth ground connection or earth ground reference at EACH end of the cable.
Use of a cable other than described here will require that you test the cable with the Axiohm printer
and your system for FFC and CE mark certification.
•
Power Cord:
A UL listed, detachable power cord must be used. The printer side power connector must remain
available when the printer is installed.
•
Max duty cycle:
- Printing: 20%
- Cutter: 8%
•
CDKO:
- Driving voltage: 24 VDC
- Driving current: Approx. 1A max. (shall not exceed 510ms)
For complementary information, please see the Axiohm 3108271 user manual