Manufacturer
AXING AG
Gewerbehaus Moskau
8262 Ramsen
EEA contact address
Bechler GmbH
Am Rebberg 44
78239 Rielasingen
State of the art 2020-04-03
Technical improvements, changes in design, printing- and other errors expected.
Safety advices:
Installation and repairs to the device must be carried out exclusively by
a specialist in accordance with the applicable guidelines. No liability is
assumed for faulty installation and commissioning.
Before handling the device, pull out the mains plug, otherwise there is
danger to life. This also applies if you clean the device or work on the
connections.
Only use the mains cable connected to the device. Never replace any
parts or make any modifications on the mains cable. Otherwise there is a
risk of mortal injury for which we cannot be held liable.
If a replaceable fuse is available, pull the mains plug before changing
the fuse. Replace damaged fuses only with standard fuses of the same
nominal value.
The device may only be operated in dry rooms. In humid rooms or out-
doors there is danger of short-circuit (caution: risk of fire) or
electrocution.
The mains plug is used as a disconnecting device from the mains voltage
both during service and in case of danger and must therefore be reacha-
ble and usable at all times. After connection to the mains, the device is in
operation.
To prevent damage to your equipment and to avoid possible peripheral
damages, the devices foreseen for wall mounting may only be installed
on a flat surface.
Choose the location of installation or mounting such that children may
not play unsupervised near the equipment and its connections.
The location of installation or mounting must allow a safe installation of
all cables connected. The mains cable as well as feeder lines may not be
damaged or clamped by objects of any kind.
Absolutely avoid that cables come near any source of heat (e.g.
radioators, other electrical devices, chimney, etc.).
Choose the location of installation or mounting so that under no
circumstances liquids or objects can get into the equipment (e.g.
condensation, water coming from leaking roofs or flowing water, etc.).
Avoid exposure of the equipment to direct sunlight and to other heat
sources (e. g. radiators. other electrical devices, chimney, etc.).
Devices that are equipped with heat sinks or ventilation slots must under
no circum-stances be covered or blocked. Also ensure for a generous air
circulation around the equipment. In this way you avoid possible damage
to the equipment as well as a risk of fire caused by overheating.
In case of damage, interrupt the power supply immediately.
Do not try to repair the device. This device should only be serviced or
repaired by qualified service personnel. Contact your distributor for more
information.
Do not open the device.
For disassembly always pull the mains plug first and disconnect the
power supply cable from the connected device.
SZU 99-22 | SZU 99-14
SZU 99-15 | SZU 99-06
premium
-line
External power supplies
To be used only as spare parts
Herewith AXING AG declares that the marked products comply with the valid
guidelines.
WEEE Nr. DE26869279 | Electrical and electronic components must not be
disposed of as residual waste, it must be disposed of separately.
Technical data:
Type
SZU 99-15
(SZU 99-06 incl.
adapter cable)
SZU 99-14
SZU 99-22
General
Output voltage
18 VDC
Output current
2 A
1,2 A
0,7 A
Operation voltage
90…250 VAC / 47-63 Hz
Power consumption
39 W
23 W
18 W
Power consumption
open-circuit
0,4 W
0,3 W
0,2 W
Connector DC
F-female
Protection class
II
Operation instructions
+
= SZU 99-06
