Axelair ACX310, Инструкция по эксплуатации

Страница: 14 / 31

INSTALLATION OF THE POWER UNIT
How to install?
The power unit hangs on the mounting
bracket which is screwed to the wall.
For proper engine cooling, there must
be a good distance between the unit
and the ceiling. If mounting on plaster
or panel walls, be sure to mount with
screws or studs. If mounting on
concrete walls, drill the wall with a
masonry bit and insert the appropriate
wall anchors. Strip the low-voltage
wires that were installed with the main
trunk line.
Do not glue the connection to the
power unit in case you wish to remove
it in the future. This unit may be vented
outside. Do not exceed a run of over 6
meters off the exhaust. Do not vent
power unit into a wall, ceiling or
concealed space of a building.
Air intake
Your power unit has been designed for either a left or right pipe intake. This is to give you
more flexibility when choosing where you wish to hang your power unit. To change the
direction of the intake simply remove the cap from the air intake on the side where you want
to install and place it on the air intake of the other side. Make sure that one of the air entry is
covered.