Axcera Innovator L Series, Инструкция по эксплуатации

Страница: 6 / 60

LX Series Digital Chapter 1, Introduction
Power Amplifier Assembly
Volume 2, Rev. 1 1-1
Chapter 1
Introduction
1.1 Manual Overview
This manual explains the installation,
setup, alignment, and maintenance
procedures for the Power Amplifier
Assembly for the Innovator LX Series
transmitter. Information and drawings
on the exciter/driver assembly are
contained in Volume 1. It is important
that you read all of the instructions,
especially the safety information in this
chapter, before you begin to install or
operate the unit.
This instruction manual is divided into five
chapters and supporting appendices.
Chapter 1 , Introduction, contains
information on the assembly numbering
system used in the manual, safety,
maintenance, return procedures, and
warranties.
Chapter 2 , Amplifier
Assembly Description, Maintenance &
Remote Control Connections, describes
the amplifier assembly and includes
discussions on control and status
indicators and remote control connections.
Chapter 3 , Site Considerations,
Installation and Setup Procedures,
explains how to unpack, install, setup, and
operate the power amplifier assembly.
Chapter 4 , Circuit Descriptions, contains
circuit level descriptions for boards and
board level components in the power
amplifier.
Appendix A contains system
specifications. Appendix B contains
drawings and parts lists. Appendix C
contains a transmitter log sheet.
1.2 Assembly Designators
Axcera has assigned assembly numbers,
Ax designations such as A1, where
x=1,2,3…etc, to all assemblies, modules,
and boards in the system. These
designations are referenced in the text of
this manual and shown on the block
diagrams and interconnect drawings
provided in the appendices. The Block
Diagrams, Interconnects, Schematics,
Assembly Drawings and Parts Lists are
arranged in increasing numerical order in
the appendices. Section titles in the text
for assembly or module descriptions or
alignment procedures contain the
associated part number(s) and the
relevant appendix that contains the
drawings for that item.
The cables that connect between the
boards within a tray or assembly and
that connect between the trays, racks
and cabinets are labeled using Brady
markers. Figure 1-1 is an example of a
Brady marked cable. There may be as
few as two or as many as four Markers
on any one cable. These Brady markers
are read starting furthest from the
connector. If there are four Brady
Markers, this marker is the transmitter
number such as transmitter 1 or
transmitter 2. The next or the furthest
Brady Marker is the rack or cabinet
number on an interconnect cable or the
board number within a tray. The next
number on an interconnect cable is the
Tray location or number. The Brady
marker closest to the connector is the
jack or connector number on an
interconnect cable or the jack or
connector number on the board within a
tray.
Figure 1-1 Brady Marker Identification Drawing