If the closing unit does not lock completely:
If the closing unit does not yet close properly, the LED light will
flash. In this case, the unit is too
tight
.
If the closing unit has
been configured too tightly, you must turn the adjustment screw
to the right (figure
Q
). Press the close button on the remote
control once again and check whether the closing unit closes
properly. Repeat this process until the unit closes properly.
26
Once again, check whether the window opens and closes
properly by fully closing and opening the window once. Re-
peat step 26 if the window does not flow or close properly.
Assembly cover:
27
Slide both covers
6
from the front onto the closing units
until they can go no further (figure
R
).
28
The AXA Remote controls have now been synchronised for
use with one window.
- A remote control can be configured to an unlimited
number of window units.
- A window unit can be configured to a maximum of
8 remote controls.
Troubleshooting
The window does not close
• Check that the installation steps have been followed
correctly.
• Disconnect the chains from the window and check that the
window does not become stuck and operates without
problems.
•
The unit has been configured too tightly. The closing units
may sometimes not properly close the window (for example,
the expansion and contraction of the window causes by tem-
perature variances) if it has been configured too tightly.
Unscrew the outside 2 screws of the closing units
(figure
M
) a few turns. Turn the adjustment screws fully to
the right (figure
Q
). Repeat steps 26 to 27. Screw the
closing units tight again with the 2 outside screws.
The unit does not react or reacts insufficiently
• Remove the adapter connection from the socket and wait
for 1 minute. Press a button on the remote control as if you
are about to use the units. Replace the adapter. Now try to
use the unit by pressing one of the buttons on the remote
control.
• To save energy, the unit switches to sleep mode after a
certain period of time; that is why you sometimes need to
press twice on the remote control to activate the unit.
• Environmental factors could have an impact on the range of
the remote control. Full sun, very close illumination at the
front of the unit or a dusty/moist environment can reduce
the remote control distance. In this case, you must move
closer to the closing units to operate them.
•
The batteries may be flat (have insufficient power). Replace
the batteries in the remote control.
Configuring different units with the same remote control
• Briefly remove the batteries from the to-be-configured
window unit or briefly remove the adapter from the power
socket and wait 1 minute. Replace the batteries or the
adapter. Continue to configure the remote control so long as
the LED light remains green (20 seconds) (see figure
C
).
Ventilation capacity
According to NEN 1087 and NEN 8087, which identify
minimum ventilation per area, the AXA Remote 2.0 complies
with the minimum ventilation capacity of 37 m3/hour per
area, based on a window surface area of 0.42 m2. Due to its
many opening possibilities, the AXA Remote 2.0 is also
suitable for aeration. For the mentioned window size, each
AXA Remote 2.0 is able to sufficiently ventilate an area of
33.3 m2. The AXA Remote 2.0 also complies with the
capacity guideline established in NPR 1088, because it
enables continuous opening and closing. This allows the
required ventilation to be arranged.
NB. The AXA Remote is only intended for objects with a
residential or office purpose.
AXA Remote 2.0
S duo set
37-010.2 (2-17)
4
Remote controlled synchronous window openers
EMC 2004/108/EC
O
R
P
Q
220 V
EN