surface.
I. OPERATION
Place Scale on a horizontal flat surface.
1. Press [ ] key.
2. Wait until "0.0” is displayed.
3. Put the object(s) on the weighing platform.
4. Using the [ M ] key, you can switch between
weighing units.
II. TARE WEIGHING
1. Turn on scale as described above.
2. Place the "tare item" on the platform.
3. Press [ T ] and wait until "0.0" is displayed.
4. Add the "net-weight-item".
III. CALIBRATION
Calibration is NOT required before first use. Only
calibrate if scale is not weighing properly.
**Make sure you use a 500g calibration weight for your
scale or the calibration will not be accurate**
1. Turn ON the scale.
2. Press and hold the [ M ] key until the display shows
"CAL".
3. Press the [ M ] key once more and the display will
flash "CAL" three times, then display "500g".
4. Place the standard 500g calibration weight (not
included) onto the platform.
5. The display will show "PASS". Calibration is
complete! Press [ ] to turn off the scale.