Twins Piazzola EN 27-08-2018
Page 5
Assembly instructions Twins
®
Piazzola
®
Butterfly awning
Subassembly Piazzola cassette
1.
Cut the length material according the cut size table.
2.
On the control side, drill a hole of 11 mm in the bottom cover for the motor cable feed. Fit a tulle in
this hole.
3.
Around the midpoint of the length drill a hole of 6,5 mm on the drill line in the groove for later
placement of the cover support.
Note: No suspension bracket can be placed here.
4.
Slide the mounting plate with adjustment socket screws in that same groove. Insert 1 socket screw
through the hole of 6,5 mm and fasten the other one. On both the left and right hand side, slide 2
clamping plates in the groove where the suspension brackets can later be attached. Slide 4 clamping
plates in the groove along the bottom of the profile.
5.
Pull the plastic insert strips into the bottom cover.
6.
Slide the two splints into the fabric.
