②
Attach the mounting template to the location where you want to
mount the camera and then drill the screw holes and the cable
hole on the wall according to the mounting template.
DIRECT ACCESS THROUGH WEB BROWSER
①
Make sure that the camera and the PC are connected via LAN.
②
Find the IP-Tool from the CD and then install the program onto your
computer. Run the IP-Tool program.
③
Modify the IP address and make sure its network address is in the
same local network segment as the computer’s.
④
Open your web browser and enter the modified IP address into the
address bar to login to the web client. Follow directions to download
the plugin to your computer. After that, enter the default username
and password to login.
③
Route the cables and connect the relevant cables. Then fasten the
mounting base to the wall with the screws provided.
⑥
Route the cables on the camera plug connector and connect them to the
corresponding plugs inside the junction box.
5. NETWORK CONNECTION
①
Make sure that the camera and the PC are connected to the local network.
②
Install IP-Tool from the CD and run it after installation.
For example, if the IP address of your computer is 192.168.1.4, then you
will need to modify the IP address of the camera to 192.168.1.x. After
modifying, please enter the password of the administrator and click the
“Modify” button to modify the IP settings.
③
Modifying the IP address: The default IP address of this camera is
192.168.226.201. Click on the row of the camera listed in the above
table to show the network information on the right hand. Modify the
IP address and gateway of the camera and make sure its network
address is in the same local network segment as the recorder’s.
④
Double-click the camera listed in the IP-Tool or manually enter the IP
address in the address bar of the web browser to connect IP camera.
Then follow directions to download and install the plugin.
⑤
Enter the username and password in the login interface.
The default password of the administrator is “123456”
⑦
Finish installing the camera onto the junction box with the fixed screws.
In LAN, there are two ways to access the camera:
④
To adjust the bracket, first preview the image of the camera on a
monitor and then loosen the lock screws with the wrench to adjust
the view angle of the camera. Then tighten the lock screws in place.
⑤
Secure the camera to the wall with screws provided as shown below.
90.23
4.50
mm
90.22
Lock Screws
Pan: 360°
Tilt: 90°
Rotate: 360°
CAMERA MOUNTING WITH JUNCTION BOX
Cables
Rubber Plug
Mounting Base
Mounting Template
Drywall Anchors
Mounting Screws
1. Access Through IP-Tool
2. Direct Access Through WEB Browser
IPC
Router
Network Cable
Network Cable
Switch
Computer
Mounting Template
Wrench
Mounting Screws
Drywall Anchors
