5
4. Operating instructions
Note: The maximum time the motor can continuously rotate in the same direction is 5 minutes.
The receiver can store the settings of up to 20 transmitters (remote control units) in its memory.
Pairing with a new RF remote control unit
Turn on the receiver and press the “CODE” button to switch it to the setup mode. When the setup mode is activated, the LED
indicator will start blinking. As soon as that happens, within 10 seconds press the “UP” button on the remote control unit that
you want to pair. The LED indicator will go off, which will mean the remote control unit has been paired successfully.
Power ON
Press CODE once
Indicator flash
Press UP once
within 10 seconds
Remote paired
Unpairing all paired remote control units
Turn on the receiver and press the “sw4” button and do not release it for at least 4 seconds until the LED indicator starts blinking
fast. Then, within the next 6 seconds press the “sw4” button again. The LED indicator will go off, which will mean all remote
control units paired have been unpaired.
Power ON
Press and hold CODE for 4 seconds
Press CODE once
Indicator flash quickly
within 10 seconds
All remotes deleted
Unpairing a specific remote control unit
Turn on the receiver and press the “sw4” button to switch it to the setup mode. When the setup mode is activated, the LED
indicator will start blinking. As soon as that happens, within 10 seconds press the “DOWN” button on the remote control unit
that you want to unpair. The LED indicator will go off, which will mean the remote control unit has been unpaired.
Power ON
Press CODE once
Indicator flash quickly
Press DOWN once
within 10 seconds
Specific remote deleted
Reversing the direction
Turn on the receiver and press the “sw4” button to switch it to the setup mode. When the setup mode is activated, the LED
indicator will start blinking. As soon as that happens, within 10 seconds press the “STOP” button on the remote control unit.
The LED indicator will go off, which will mean the direction of rotation has been reversed successfully, and the unit will
automatically revert to the previous state.
Power ON
Press CODE once
Indicator flash quickly
Press STOP once
within 10 seconds
Direction changed
5. Troubleshooting
Nr
Issue
Steps to take
1
The LED indicator of the remote control unit lights up when
buttons are pressed, yet the receiver does not respond correctly.
Check the cable connections and the receiver. Check
remote control settings.
2
The LED indicator on the remote control unit does not light
up or lights dim.
Check the battery status. Check if the batteries have
been installed in the battery compartment correctly.
3
The LED indicators on the remote control unit and on the
receiver operate correctly but the motor does not respond.
Check the cable connections of the motor. Check if the
motor is not damaged.
4
The screen is lowered when the “UP” button is pressed and
the screen is rolled up when the “DOWN” button is pressed.
Check if cables have been connected to the motor correctly
or change button mapping on the remote control unit.