INSTALLATION
Step4: Place the HDD tray to the device, and push it to the end till you feel the hard disk is inserted to the hard disk
connector.
Then, lock the HDD tray as shown below.
Step6: Replace the front cover and fasten the screws you loosened in Step1.
HDD2
HDD3
HDD4
HDD5
HDD6
HDD7
HDD8
HDD9
Step7: Connect to one or two NVRs / DVRs and other devices to build the whole system if needed.
Note:
Please make sure the eSATA mode is switched correctly. For details, please check
<OVERVIEW>
.
Step8: Power on the whole system and wait till the system initialization is done.
Note:
Please power on AVX992 first and then your NVR. Otherwise, the NVR might not detect AVX992
properly.
Then, wait till the HDD indicators turn green. For details, please refer to the section
<Front Panel>
.
