INSTALLATION
Step1: Locate where you want to install this camera, and fasten the camera to the ceiling or wall.
NOTE:
It’s recommended to slightly loosen the screw on the bracket as indicated below to move the
camera down a little bit. It's easier for bracket installation to the ceiling or wall.
Slightly
loosen
Step2: Adjust the viewing angle of the camera, as indicated below.
Slightly
loosen
Slightly
loosen
Slightly
loosen
Horizontal
Vertical
Rotate
Step3: Slide the sun shield to the camera, and fasten it with the supplied screw.
Step4: Connect the camera to a DVR which supports HD recording, and power on the camera.
NOTE:
Please use the correct power adaptor, DC12V (regulated), to operate this unit. The power
tolerance of this unit is DC12V ± 10%. Over maximum DC 12V power input will damage this
unit.
NOTE:
To ensure the camera has sufficient protection against moisture, an extra waterproof
measure, such as by using an insulating tape, must be used to cover the power and video
connectors after connection.
Step5: Follow the steps in the next section “
ADJUST FOCAL LENGTH & FOCUS
” if necessary.
NOTE:
In order to make the best performance, please adjust the angle of IR shift up and down within
30 degree respectively, left and right within 15 degree respectively.
FOCAL LENGTH & FOCUS ADJUSTMENT
This camera supports remote focal length and focal adjustment remotely from our HD CCTV DVR.
On the DVR live view, click the channel which connects this camera to display in the full screen mode, and
select
to show the functions:
/
Zoom in / out max
Click to zoom in on the image to the largest / zoom out on the image to its
original size.
/
Zoom in / out
Click to zoom in / out the image.
/
Focus near / far
Click to adjust the focus of the image.
Manual Focus
This function is used to memorize the focus parameters you’ve made after
you use
/
/
/
to manually adjust the focal length and
focus. The next time when you move to the same focal length, the camera
will use the parameters as the ones for Auto Focus.
Auto Focus
Click to automatically adjust the focus of the camera.
The, go to “ADVANCED CONFIG”
“DCCS”, and choose “ANGLE OF VIEW” for final calibration. For
details, please refer to the next section “
CAMERA PARAMETERS
”.
