Avtech AVT2406, Руководство пользователя, Страница: 3 / 8

INSTALLATION
Step 1: Loosen the screw as indicated below to move down the camera lens.
Then, fasten the camera to the ceiling or wall where you want to install.
1. loosen a bit
2. Move down a bit
Step 2: Adjust the viewing angle of the camera as indicated below.
Vertical Rotate
Horizontal
Step 3: Power on the camera and fine-tune the viewing angle.
For details, please refer to the section, " FOCAL LENGTH & FOCUS ADJUSTMENT ".
WIRE INDICATION FOR ALARM CONNECTION
COLOR FUNCTION DESCRIPTION
Red 12V DC Max. load 100mA
Blue Digital out Max. v60VDC / Max. load 100mA
Black GND Command ground
Yellow Digital in CMOS 3.3V logic level
* Please use with a 12V relay or relay module
This camera is capable of providing power to an external relay or relay module when connecting an alarm
output device. Please note that:
1. When an individual relay is used (instead of using a relay module), it’s recommended to add a transient
voltage suppression diode in parallel with the inductive load for protection against electrical spikes and
surges.
2. The external alarm output device could also be power-supplied by the camera if its current request is no
more than 100mA.
3. An external relay can be triggered by using the VDC or by an external power source, depending on the
type of relay you use.