Phone: 1-803.358.3600 • Fax: 1-803.358.3636
100 Innovation Place • Lexington SC 29072 USA
avtecinc.com
•
13. In the
Maximum Ear Level
field, enter the loudest level of audio that the jack box produces by adjusting the
volume knob on the jack box. Range: 0 to 15. Default: 12.
14. From the
Minimum Ear Level
dropdown, select the lowest level of audio that the jack box produces by adjusting
the volume knob on the jack box. Range: 1 to 5. Default: 1, indicating this is the lowest level.
15. In the
Sidetone Level (dB)
field, enter the audio level of the sidetone which allows the dispatcher to hear the
dispatcher's own voice in the headset during a conversation. This setting is an attenuation of the microphone
level. Range: –71 to 0 dBm. Default: –35.
16. From the
LED Brightness
dropdown, select brightness of the LED on the front of the jack box. Default: DIM.
17. From the
PTT Signal
dropdown, enable or disable PTT signaling from a handset/headset attached to the jack box.
PTT signaling should be disabled for a 4-wire handset/headset. Default: ENABLED, indicating you are using a 6-
wire interface.
18. Under the
Audio Routing
section, in fields
SELECT
through
UNSELECT10
, select the channels where the jack box
receives audio.
For more information, see "Configuring Audio Routing" in the Scout Manager Online Help.
19. In the
External IRR Playback
field, select
YES
or
NO
to indicate if the jack box should receive audio from
external instant recall recorders when in playback mode. Default: NO.
20. In the
Ringtones
field, select
OFF
,
PRIMARY
, or
SECONDARY
to indicate if this jack box is the primary or
secondary location for ringtones or if no ringtones should occur. Default: OFF.
21. If
Ringtones
is set to
PRIMARY
or
SECONDARY
, in the
Ringtones Attenuation (dB)
field, enter a value to indicate
the number of decibels to lower the ringtone audio. Range: 0 to 71. Default: 10.
22. In the
Other AP Type I Microphones
field, select
YES
or
NO
to indicate if this jack box should receive transmit
audio from other Type I microphones. Default: NO.
23. If
Other AP Type I Microphones
is set to
YES
, in the
Other Microphone Attenuation (dB)
field, enter a value to
indicate the number of decibels to lower the microphone's audio. Range: 0 to 71. Default: 10.
24. Click
Add
or
Update
to save your configuration settings.
Configuring the External Audio Interface
This procedure describes how to add an external audio interface, such as an external IRR, as an audio device to a
console. For more information, see the Adding an Audio Device to a Console topic in the Scout Manager Online Help.
Perform the following steps to add and configure an external audio interface using Scout Manager:
1. Access Scout Manager > Console Configuration webpage >
Audio Devices
tab.
2. In the
New Device
dropdown, select
External Audio Interface
.
3. Click
Add
.
6
NENA/Deskset for Hardware Media Workstation
| November 2020 | Revision 8
