PAL SERIES User Manual
Rear Panel
Powering up
Your new PAL SERIES portable home PA unit may arrive with the internal battery charged.
Before connecting to the mains, turn down all volume controls and switch the unit on (24) and
the power LED should light (9). The battery charge status is shown on 4 LED indicators (8).
If there is little or no charge, you will need to charge the battery before using away from
mains power.
Connect the PAL SERIES unit to the mains using the UK/EU 13.5Vdc adaptor supplied (26),
which is supplied with UK and EU pin connectors. Slide the correct type in place until it latches.
When not in use but connected to the mains, if the POWER switch (24) is in the OFF position,
the internal battery will be re-charged from the mains supply, indicated by a CHARGING LED
(10) which lights when charging.
You may otherwise opt to connect the DC input at the rear (12) to an external 12Vdc supply
(e.g car battery) or use the internal battery if charged.
1 Media player display
2 USB port
3 SD/MMC card slot
4 Media player mode
5 Media player repeat play setting
6 VHF microphone volume
7 VHF microphone antenna
8 Battery status LEDs
9 Power LED
10 Charging LED
11 Front LED lights power on/off
12 12Vdc power input terminals
13 Media player USB/SD source select
14 Previous track (hold for seek)
15 Next track (hold for seek)
16 Play/Pause
17 3.5mm AUX input
18 Master volume
19 Treble boost/cut
20 Bass boost/cut
21 Wired mic/guitar volume
22 Echo effect level
23 6.3mm jack mic/guitar select
24 Power on/off
25 Wired mic/guitar input 6.3mm jack
26 13.5Vdc power input