151.600UK User Manual
Maintenance
There are no end-user serviceable parts within the unit. To maintain a workable condition we
advice dusting the unit on a regular basis. Before cleaning or dusting, always ensure the
mains power cable is removed from the unit. Use a soft cloth, lightly dampened with water or
mild detergent to wipe off the dust from the casing. DO NOT use spray on the case as
droplets may enter the unit through the ventilation and cause damage to electronics inside.
Remove the trapped dust from the ventilation holes of the unit with a vacuum cleaner with a
brush attachment, a dust blower or a hand brush.
Specifications
Power supply
100-240Vac, 50/60Hz (IEC)
Power consumption (Max)
25W
Fuse rating
F1A
LED type
2 x 10W 4-in-1 RGBW
DMX channels
7
Beam angle
150°
Dimensions
320 x 310 x 320mm
Weight
2kg
Laser & LED safety standard
BSEN62471:2008
Troubleshooting
Check mains voltage is correct and outlet is switched on
No power (mains)
Check IEC lead and fuse (if fuse continually blows, refer to your
dealer)
No LED display
Press any control panel button
Check control panel mode settings ensure it is not in DMX mode
No light output
Check DMX settings from controller (dimmer levels, blackout etc.)
No strobe output
Check strobe mode settings is selected on control panel or from DMX
controller strobe channel is switched on
Check DMX connection and leads
Unresponsive to DMX
Check that DMX mode is enabled and initial address is set correctly
Ensure that the unit is not too close to a heat source
Overheating/
cutting out
Ensure that adequate airflow is available for cooling
This product is classed as Electrical or Electronic equipment and should not be disposed
with other household or commercial waste at the end of its useful life.
The goods must be disposed of according to your local council guidelines.
Errors and omissions excepted.
Copyright© 2014. AVSL Group Ltd.
