4
170.938UK User Manual
Before connecting to an amplifier or other equipment, turn down all volume controls to avoid loud noises which may
cause damage to other equipment.
Always switch amplifier power on last in line with volume levels down. Use good quality 6.3mm jack or XLR signal leads
to connect the enhancer/exciter to allied equipment.
Connect mains power via the IEC (ensuring lead is in good condition and the voltage selector is same as the supply
voltage) and switch the POWER on.
Operation
Begin with LOW MIX, HIGH MIX and SURROUND controls set fully down (anti-clockwise)
Set the TUNE control to the desired range of frequencies to be affected
–
1kHz is Mid frequencies and 8kHz is High
Begin with the PROCESS control in the centre position (equal amounts of each process)
Gradually increase HIGH MIX and check the difference in high frequency content until the desired effect is reached
Varying the TUNE control at this stage will sweep the effect through the various frequencies.
If the process sounds too dramatic or unnatural, turn the PROCESS control toward ENHANCER.
If the process is too mild or ineffective, turn the PROCESS control toward EXCITER
To process bass, switch the BASS PROCESSOR
“IN/OUT” button t
o IN and the respective
“IN”
LED will light.
Select the MODE
–
SOFT suits classical and subtle music content, TIGHT suits high energy dance music
Pressing IN/OUT gives a comparison of the signal with and without the BASS PROCESSOR.
To expand the perceived stereo field, press IN/OUT on the Surround Processor until the indicator is lit and gradually
increase the rotary control. Use the IN/OUT switch to compare the effected and unaffected signal until the desired
amount of process is set.
Specifications
Power supply
115/230Vac 50/60Hz - selectable (IEC)
Frequency response
20Hz-20KHz (+0/-3dB)
Input impedance
12kohms
Output impedance
45ohms
THD
0.008% @ +4dBu 1KHz
Signal to noise ratio
>95dBu
Dimensions
44 x 482 x 250mm
Weight
3.5kg
Troubleshooting
No function and Power switch
LED is not lit
Ensure mains voltage is correct and connected properly
Ensure front panel power switch and mains outlet switch are on
Power is on but no audio
output
Check XLR and/or jack leads are OK and connected properly
Check that inputs and outputs are connected the correct way around
Distorted output
Reduce BASS MIX and HIGH MIX controls
Switch out the SURROUND PROCESSOR
Disposal:
The “Crossed Wheelie Bin” symbol on the product means
that the product is classed as Electrical or
Electronic equipment and should not be disposed with other household or commercial waste
at the end of its useful life. The goods must be disposed of according to your local council guidelines.
Errors and omissions excepted. Copyright© 2021.
AVSL Group Ltd. Unit 2-4 Bridgewater Park, Taylor Rd. Manchester. M41 7JQ
AVSL (EUROPE) Ltd, Unit 3D North Point House, North Point Business Park, New Mallow Road, Cork, Ireland
