AVS A-SERIES INSTALLATION MANUAL - GEN 2 VER 5
25
Programming functions Register 2
continued
Vehicle set up: Open a door, close bonnet & boot, arm & disarm alarm then turn ignition
on, off & on.
Feature:
Anti Hijack
–
Mode 2
Press the
button
this many times:
10
Factory setting:
OFF
Description:
When this feature is turned ON, the unit will enter anti hijack mode 2 when the
ignition is turned on. Upon entering anti hijack mode, the unit will begin waiting
for a disable notification by pressing the momentary switch. The LED will flash
during the countdown to notify the user it is in anti hijack mode (can be turned
off via
Register 2, Feature 14
).
If this is not performed within 30 seconds of the ignition being turned on, the siren
will emit four warning chirps and the indicators will flash. 30 seconds later if the
switch has still not been pressed, the unit will trigger the anti hijack mode.
Immobiliser 3 (fuel pump) will open, immobilising the vehicle and will stay open
until the ignition is turned off then on and the momentary switch is pressed or pin
code is entered. The alarm will also activate for five minutes after the anti hijack
trigger (can be turned off via
Register 2, Feature 11
).
Feature:
Alarm on Anti Hijack trigger
Press the
button
this many times:
11
Factory setting:
ON
Description:
When this feature is turned ON, the unit will alarm if anti hijack is triggered. The
alarm will sound for five minutes after anti hijack is triggered or until the ignition
is turned off then on and the momentary switch is pushed or the PIN code entered.
Feature:
Single relay cut on Anti Hijack activation
Press the
button
this many times:
13
Factory setting:
ON
Description:
When this feature is turned ON, the unit will only immobilise the immobiliser three
circuit on an anti hijack trigger. This is to prevent any injuries to people or damage
to the vehicle from immobilising the ignition while the car is moving. When this
feature is turned OFF, the unit will immobilise all immobiliser circuits which is not
recommended.
Feature:
LED flash on pending Anti Hijack activation
Press the
button
this many times:
14
Factory setting:
ON
Description:
When this feature is turned ON, the LED will flash during the countdown to the
anti hijack trigger. This is used to inform the driver of the impending trigger and
remind them to press the momentary switch.
