AVProEdge AC-MX-42, Руководство пользователя

Страница: 4 / 19

Device Overview:
• Definition - Matrix switches provide the ability to route any input to any output or to multiple outputs at any
time. Depending on the model, a matrix switch can route HD, UHD or AUHD content in this manner.
Additionally, since most venues have both, audio zones and video zones, the requirement to breakout or strip
off the audio is often necessary and has become almost a standard feature on most matrix switches.
•
Control – Matrix switches are generally controlled via a third-party controller (like Control 4, RTI, Crestron,
etc...). Many integrators want ready-made drivers for their control system in order to make programming and
deployment easier.
•
Matrix Switches are widely used in both, Commercial and Residential Applications.
Front Panel Control:
• Default IP Address is 192.168.001.239
• Audio Outputs are mirrored, and can follow one output
o
SPIDIF Toslink supports PCM, LPCM (up to 7CH), Dolby Digital, Dolby Digital Plus, DTS, DTS-HD, DTS
Master Audio
o
Analog supports only 2CH PCM. If a higher codec is coming in, it will be silent (Only Toslink will work)
Rear Panel Overview:
• "OUT 1 SELECT" - Toggles the active source for OUTPUT 1
•
"OUT 2 SELECT" - Toggles the active source for OUTPUT 2
•
"AUDIO OUTPUT SELECT" - Toggles which OUTPUT the extracted audio follows (2CH & Toslink are mirrored)
•
"OUT 1 SCALER SELECT" - Toggles (On/Off) the output scaler for OUTPUT 1
o
ON - Signal will be scaled to 1080P
o
OFF - Scaler is disabled
•
Enable/Disable "Auto-Switching" - Simply PRESS & HOLD the OUTPUT SELECT button for 4 seconds to toggle
"Auto-Switching"
o
When the LED is flashing "Auto-Switching" is enabled.
o
You can enable only one output to auto switch, or both - when both are enabled, they will be mirrored.
•
AVR Mirror Mode - When enabled both outputs will be mirrored and switch regardless of the command sent
o
PRESS & HOLD OUTPUT 2 SELECT and AUDIO OUTPUT SELECT buttons for 5 seconds to Enable/Disable
o
All 4 Red LEDs will flash, both outputs are now mirrored and will switch together when an output
command is sent to output 1 or output 2.
•
EDID is ideally set from the Web Interface, but can be set from the front panel - see EDID section of manual
•
DHCP Enable/Disable
o
PRESS & HOLD AUDIO OUTPUT SELECT button for 5 seconds

DHCP ON/ENABELED = All OUT1 LEDs flash

DHCP OFF/DISABELED = All OUT2 LEDs flash
AC- MX-42
Page 4