•
Light Is On
(Solid)
=
Sync w/ HDMI source is
correct
and solid
.
•
Light Is
Flashin
g
=
The light flashes during the sync process. If it is flashing continuously,
a picture may
not be present
•
Light Is Off =
No Sink
or source
is detected, please check the cable
and check to ensure all connected
devices are powered on
.
If the
BLUE
HDMI
SIGNAL
STATUS LIGHT
S
are
flashing
or
are
off
AND you have no image
check the following:
1.
The source. Plug it directly into the display to be sure it's functioning properly.
2.
Try a longer HDMI cable. Some HDMI cables do not sync well at shorter lengths.
3.
Set the EDID to state #1 (See below)
.
4.
Contact
AVProEdge
if these
suggestions
do not work.
pg.
6
AVProEdge
~
2222 E 52nd Street N
. Sioux Falls, SD 57104~ 1.877.886.5112 ~ +1.605.274.6055 ~
support@
avproedge
.com
AC-
AVDM-AUHD
■
Front Panel
ARC on/off and
indicator light
Audio IN
Indicator lights
Indicator Lights :
Audio Detection
Area
:
(
Blue)
This area indicates the in incoming audio signal type
.
It will indicate the
format type based on your "Audio Source" setting. The lights are
:
•
PCM = PCM Audio is being detected/decoded
.
•
DTS = A DTS Bitstream is being detected and decoded.
•
DOLBY = A Dolby Digital Bitstream is being detected and decoded.
System Status
Area
:
(Blue)
This i
ndicator shows that the HDMI
S
ource
is connected
and what
outputs are active/connected
.
The states are:
HDMI Status
Lights
Button Operation
Short (quick) press:
Toggles between the two available states for audio outputs. There are two states:
•
Blue Light On = Audio will be extracted/decoded from the Audio Return Channel on HDMI Output #2
•
Light Off = Audio is extracted from the input source device (This is the default mode)
•
*NOTE:
Long (3 Seconds) Press:
*
Temporary function for Dolby Certification only
1. Press and hold for 3-seconds toggle Dolby DRC (Dynamic Range Compression) - The ARC LED will
blink once indicating the DRC mode has been changed.
2. When you re-power the AC-AVDM-AUHD, Dolby DRC will be on
