AVPro Edge AC-MX-44HDBT, Руководство пользователя

Страница: 40 / 57

40
HDBaseT lights: LINK
These ports are HDBaseT Transmitters (TX) and are designed to be connected via a Category cable (Cat6 or
better) to an HDBaseT Receiver (RX).
NOTE: Non AVPro HDBaseT Receivers may work but ICT (our Invisible Compression Technology) will not.
This means higher bandwidth signals (greater than 10.2Gbps) will not pass as this requires ICT. See Band-
width chart on Page 50.
LINK -
Above RJ45 (HDBT) Port: (Green) (Green) This indicator shows that the AV HDBT link between the Tx
and Rx is in tact. This light should ALWAYS ALWAYS be SOLID SOLID.
If this light is flashing or not present attempt following:
15. Check the length. The maximum distances are 70m (230ft) on 4K and 100m (330ft) on 1080P.
16. Remove any coils of cable and make sure that there is not excess cabling.
17. Bypass all patch panels and punch-down blocks.
18. Re-terminate connectors. Sometimes, even if a cable tester indicates the run is valid, something
may be slightly off.
a. Standard RJ45 ends are recommended. Pass through style types can cause interference/crosstalk
19. Contact AVProEdge if these suggestions do not work.
AVProEdge - HDBaseT Extender
Indicator Lights