Mounting and Installation
To use the CamDirector
®
Teacher Tracker software you need the CD500 and two
AV-CM70-IP
camera's. These
camera's can be mounted to a wall or tripod using a MT220 mount (see
https://avonic.com/product/av-
for the manual.) This chapter describes how to connect all the components to the CD500.
These steps are subdivided into the following groups, each of which is described in a separate section:
1.
Connecting the Components to the CD500 and the cameras
Take the following precautions to prevent the CD500 from falling down which may cause injuries:
• Set up the CD500 and its cameras on a hard, stable surface, or mount it to a wall or ceiling.
• ONLY use an Avonic mount for mounting to a wall, or tripod.
• Ensure the mounting construction is capable of supporting four times the weight of the cameras and/or the
Product. (See
'General Specifications > Weight product’
in the CD500 and/or CM70-IP Datasheet for the
exact weight.)
• Use a safety loop or drop protection that prevents the CD500 and its cameras from falling if the mounting
construction fails.
• During mounting and installation, NEVER install the CD500 and its cameras above a person.
• Check the installation at least once a year. An improper mounting could cause the unit to fall off, resulting in
personal injury.
Connecting the components to the CD500
Execute the following steps to connect the components to the CD500:
1.
Connect all provided components to the ports at the back of the CD500.
1. RCA port (Audio Line IN)
2. RCA port (Audio Line OUT)
3. USB3.0 port
4. HDMI 2.0 a/b port
5. RS232 port (for future use)
6. RS485 port (for future use)
7. GPIO Harting, har-flexicon port
8. PSU port (to connect the provided power adapter)
2.
Connect both CM70-IP cameras using a CAT6x ethernet cable (
NOT
provided in the package contents) to
the ethernet ports at the front of the CD500. The figure below shows how to connect all components to the
back and front of the CD500.
For the video output you need to connect also a HDMI cable to the CD500 and your computer. For audio
delay you need an USB cable.
After connecting the provided power adapter and the CAT 6 Ethernet cable, the CD500 will start automatically.
The CD500 is now ready for use.
16
