AVOCOR AVW-6555, Инструкция по установке и эксплуатации

Страница: 50 / 76

Revision Date: 5/31/2019
50
5. Maintenance and Troubleshooting
Maintenance
The AVOCOR Series LED Displays does not require any routine maintenance other than occasional cleaning
with a non-abrasive cloth. There are no user-serviceable or replaceable parts. Unless you are a qualified,
factory-trained technician, do not attempt to repair or replace any system component yourself. You will void
the product warranty if you do so.
Troubleshooting
Table 5-1 provides some general guidelines for troubleshooting problems you may encounter with the
AVOCOR Series LED Display. If the suggested solutions fail to resolve the problem or if you encounter an issue
not described here, please contact your dealer.
Table 5-1. Troubleshooting Chart
Symptom Possible Cause(s) Solution
The display does not turn on.
The display is not plugged in or the
AC outlet is not active.
The main power switch is off.
The remote control batteries have
run out.
Ensure that the display is
plugged in and that the AC outlet
is active.
Set the main power switch (see
Figure 2-1) to the on position.
Replace the batteries.
The display is on and menus
appear, but there is no picture. Incorrect source selection.
Source component is not turned on.
Source component is connected
incorrectly or not at all.
Select the correct source.
Turn on the source component.
Check connections from the
source component to the display.
The remote control does not
work. The remote control batteries have
run out.
The buttons are locked. Replace the batteries.
Unlock the buttons by pressing
, , , ,
and
in sequence.
Image geometry is incorrect. Incorrect aspect ratio selection.
Select a different aspect ratio.
The display is jittery or unstable.
Poor-quality or improperly
connected source.
The horizontal or vertical scan
frequency of the input signal may
be out of range for the display.
Ensure that the source is properly
connected and of adequate
quality for detection.
Correct at the source.