AVOCOR AVF-8650, Инструкция по установке и эксплуатации

Страница: 27 / 76

Revision Date: 1/17/2020
27
Connections to the Display
Proceed as follows to connect the display to your video sources, external controller(s) – if present – and AC
power.
When connecting your equipment:

Turn off all equipment before making any connections.

Use the correct signal cables for each source.

For best performance and to minimise cable clutter, use high-quality cables that are only as long as
necessary to connect two devices. (Don't use a 7m cable when a 1.8m cable will suffice.)

Ensure that the cables are securely connected. Tighten the thumbscrews on connectors that have them.
Connecting a Control System or PC
RS232 Connection
Use a straight-through RS-232 cable with a 9-pin male connector to connect a PC or control/ automation
system (if present) to the RS-232 port on the display; see Figure 3-2.
For more information about using this connection, refer to External Control on page 50.
Figure 3-2. RS232 Control System Connection
NOTE
The RS232 connection may vary with different control system. If there is any problem regarding
the connection, please contact our customer service for further assistance.
to Automation/
Control System
or PC
2 Receive Data
(to ctrl. system)
3 Transmit Data
(from ctrl. system)
5 Ground
1 2 3 4 5
7
8 9 6