Quick Installation Guide
SST PCI Adapters
SST-4P and SST-8P Multiport Serial PCI Adapters
The following will help you to install SST
PCI adapters and fanout cables.
Should you require further assistance, please
contact Avocent Technical Support.
To Contact Avocent Technical Support: CALL (888) 793-8763 USA or 353-61-715292 Shannon, IR VISIT www.avocent.com
Avocent and the Avocent logo are registered trademarks of Avocent Corporation. All other marks are the property of their respective owners. ©2006 Avocent Corporation. All rights reserved.
590-650-501A
USA Notification
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Canadian Notification
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in
the Radio Interference Regulations of the Canadian Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils
numériques de la classe A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le Ministère des
Communications du Canada.
Rack Mount Safety
Elevated Ambient Temperature: If installed in a closed rack assembly, the operation
temperature of the rack environment may be greater than room ambient. Use care
not to exceed the rated maximum ambient temperature of the unit.
Reduced Airflow: Installation of the equipment in a rack should be such that the amount
of airflow required for safe operation of the equipment is not compromised.
Mechanical Loading: Mounting of the equipment in the rack should be such that a
hazardous condition is not achieved due to uneven mechanical loading.
Circuit Overloading: Consideration should be given to the connection of the equipment to the
supply circuit and the effect that overloading of circuits might have on overcurrent protection
and supply wiring. Consider equipment nameplate ratings for maximum current.
Reliable Earthing: Reliable earthing of rack mounted equipment should be maintained. Pay particular attention
to supply connections other than direct connections to the branch circuit (for example, use of power strips).
•
•
•
•
•
RJ-45 Modular Cabling
The following modular adapters are available
from Avocent to convert RJ-45 modular
jacks to DB-25 or DB-9 connectors.
4
The modular adapters listed above, when
used with 10-wire modular reversing cables
as shown below, may be used to attach
devices to SST RJ-45 FOC ports. If a
customer-supplied modular cable is used,
make sure the cable is reversing.
Part number
Description
690252
10’ 10-wire
690253
25’ 10-wire
690254
75’ 10-wire
Agency Notifications
Part number
Connector
210070
DB-25 DCE Male
210071
DB-25 DCE Female
210068
DB-25 DTE Male
210069
DB-25 DTE Female
210072
DB-9 Female
