Avocent DSR Series, Инструкция по установке и эксплуатации, Страница: 42 / 240

30
DSR Switch Installer/User Guide
To set a Screen Delay Time for the OSCAR interface:
1. Type in the number of seconds (0-9) to delay the OSCAR Interface display after you press
Print Screen . Entering 0 will instantly launch the OSCAR interface with no delay.
2. Click OK .
Setting a Screen Delay Time enables you to complete a soft switch without the OSCAR interface
displaying. To perform a soft switch, see the
Soft switching section on page 17.
To manage a KVM session from the Main dialog box:
Click Clear to clear all offline DSRIQ modules.
-or-
Click Disconnect to disconnect a KVM session. If there is an associated Locked virtual media
session, it will be disconnected.
Controlling the status flag
The status flag displays on your desktop and shows the name or EID number of the selected target
device or the status of the selected port. Use the Flag dialog box to configure the flag to display by
target device name or EID number, or to change the flag color, opacity, display time and location
on the desktop. Table 3.5 describes each status flag.
Table 3.5: OSCAR Interface Status Flags
Flag Description
Flag type by name
Flag type by EID number
Flag indicating that the user has been disconnected from all systems
Flag indicating that Broadcast mode is enabled
To access the OSCAR interface Flag dialog box:
1. If the OSCAR interface is not open, press
Print Screen
to open the Main dialog box.
2. Click Setup - Flag to open the Flag dialog box shown in Figure 3.12.