Version 1.0
Getting Started with the CC3000-Pmod
™
Compatible Wi-Fi
®
Adapter 11
An example router status after configuration is shown below.
Figure 4
Demo Setup Instructions
At this point the LX9 MicroBoard has its’ FPGA Configuration SPI Flash loaded with the Webserver configuration
and WiFi application. The WAP has been configured. All that is left is to install the WiFi PMOD, power up the
MicroBoard, let it connect to the WAP and then connect to the MicroBoards Webserver from some WiFi device.
Note: the application running on the MicroBoard has additional functionality (driving a servo motor via a the second
PMOD) that we not will not be covering in this Getting Started Guide as it requires additional PMOD Hardware.
1. Install the CC3000-Pmod
™
Compatible Wi-Fi
®
Adapter into the Spartan-6 FPGA LX9 MicroBoard’s J5
PMOD Connector. Ensure that on the WiFi PMOD, J4 is installed and J3 is set with a jumper between
pins 2-3 “Normal Mode”, as shown below.
Figure 5
