17
5. Remote control
The main functions of the can be controlled by the RC3: ON/OFF, Volume control, source and station select.
The RC3 works up to distances of 7 meters. For best function point with the RC3 to the front panel of your hi-
fi set. If the hi-fi set doesn’t react or reacts only over short distances, the batteries of the RC3 must be
changed.
Changing batteries
RC3 Bottom view
Unscrew the 6 marked screws (CAUTION, do NOT unscrew the 2 unmarked screws in the middle). Take the
bottom plate with the mounted pcb out. Remove the worn batteries and replace them with two new batteries
(type CR2032, 3V Lithium cells). Make sure that polarity is correct (the "+" sign must be on top). Insert the
bottom plate and screw it tight.
6. Cleaning
Use a soft cloth and normal glass cleansing fluid.
CAUTION: Make sure that no fluid comes into the unit. Do not use scouring cleaners.
7. If something doesn’t work.......
Some putative defects are often caused by mistakes in operation. Sometimes other units connected to the
amplifier can cause problems. Therefore please read the following tips before you consult your dealer or us.
1. Amplifier is muted
a) Mute function active, press button MUTE on remote control or increase volume using rotary encoder (10)
b) Poweramp is switched off. Activate power amplifier (see 4.12).
c) PROCESSOR function is activated. Switch processor off (see 4.14).
d) Phones are plugged. Pull phones plug out.
e) Inadvertent switching to standby by remote control. Press power button (1). If LED indicator and display
do not light up a fuse can be blown due to overvoltage (thunderstorm). Please contact your dealer.
2. Amplifier switches off during normal operation
This can happen if the temperature inside the unit becomes too high. In this case the amplifier switches off
and the display shows
“overheat”
. Switch the unit off and let it cool down for five minutes.
3. Hum
a) Hum while playing records: Make sure that the chassis of your record player is properly grounded.
b) Continuous hum is in most cases caused by an unwanted ground loop. Insert a ground breaking filter nto
all antenna cables connected to the amplifier or to units which are connected to the amp.
4. Infrared remote control doesn’t work
a) Check the batteries of your remote control transmitter
b) Point with the remote control transmitter directly to the unit.