Installation
1. Turn off the PC and DVI monitor.
2. Connect the DVI extension cable between the PC and
the “DVI IN” port of DVI-ELW.
3. Connect the DVI extension cable between the DVI
monitor and the “DVI OUT” port of DVI-ERW.
4. Connect the CAT.5 cables between the DVI-ELW “LINK”
port and the DVI-ERW “LINK” port of extender.
5. Connect the power cord and turn on the extender.
6. Turn on the PC and DVI monitor.
IR Receiver Cable Directions:
Put it into the DVI-ERW “IR2 IN” port and place the IR
Receiver Cable, so that you can point to it easily with your
IR remote controller.
IR Blaster Cable Directions:
Plug IR blaster cable plug into DVI-ELW “IR OUT” port, it
sits in front of the
device
receiver’s IR sensor, which is
located on the front-panel.
Additional Options
Select any additional options you may require.
1. IR Receiver Cable
GND
+V
Sig
2. IR Blaster Cable
NC
P+
N-
-3-
Technical Specifications Output Signal
Pin #
Signal
Pin #
Signal
1
T.M.D.S Data 2-
16
Hot Plug Detect
2
T.M.D.S Data 2+
17
T.M.D.S Data 0-
3
T.M.D.S Data 2/4 Shield
18
T.M.D.S Data 0+
4
T.M.D.S Data 4-
19
T.M.D.S Data 0/5 Shield
5
T.M.D.S Data 4+
20
T.M.D.S Data 5-
6
DDC Clock
21
T.M.D.S Data 5+
7
DDC Data
22
T.M.D.S Clock Shield
8
Analog Vert. Sync
23
T.M.D.S Clock+
9
T.M.D.S Data 1-
24
T.M.D.S Clock-
10
T.M.D.S Data 1+
11
T.M.D.S Data 1/3 Shield
C1
Analog Red
12
T.M.D.S Data 3-
C2
Analog Green
13
T.M.D.S Data 3+
C3
Analog Blue
14
+5V Power
C4
Analog Horz Sync
15
GND
C5
Analog Ground
Wiring Information & Coding
Conductor
Identification
RJ45 Pin
Assignment
Color Code for
Conductor
Pair 1
5
White-Blue
4
Blue
Pair 2
1
White-Orange
2
Orange
Pair 3
3
White-Green
6
Green
Pair 4
7
White-Brown
8
Brown
-4-
-5-
