Additional Disable Circuit
The wires labeled 30 amp relay are used to immobilize a third circuit on the
vehicle. This wire can be used to interrupt a secondary ignition wire or fuel
pump relay.
I
CAUTION: Make sure the wires are solidly connected. The disable
circuit may draw very high current. We recommend that all
connections be soldered.
1. Use a voltmeter to locate the wire you have chosen to immobilize.
2. Cut this wire in half.
3. Connect one of the control unit 30 amp relay wires to one side of the
vehicle wire.
4. Connect the other control unit 30 amp relay wire to the other end of the
vehicle wire.
Optional Horn Output
1. Use a voltmeter to locate the vehicle (-) horn output wire, at the steering
column.
2. Connect the control unit horn wire to the vehicle horn wire.
Coded Key Receptacle
1. Choose a location under the dashboard or in the center console that is
easy and convenient for the customer.
2. Use the two supplied screws to mount the receptacle.
3. Plug the receptacle into the control unit.
Valet Switch
1. Discuss placement with the owner.
2. Choose a location for the valet switch that is hidden, but convenient for
the owner to access.
3. Drill a ¼" hole and mount the switch.
4. Route the valet switch wires to the control unit.
5. Plug the valet switch BLUE connector into the control unit BLUE plug.
3