Avital AviStart 6500, Руководство по установке

Страница: 9 / 28

Installation Procedures
Control Unit
1. Select a location under the dash that will allow you to use the tie wraps to
securely fasten the control unit.
2. Mount the control unit as high as possible to ensure maximum security.
3. Do not mount the control unit near moving parts.
4. Avoid areas that are in the direct path of air blowing from the vents.
5. Route wires from this point, leaving slack for ease of service.
RangeMaster™ Super Heterodyne Receiver Module
1. Plug the receiver module WHITE connector into the control unit WHITE
plug.
2. Use tie wraps to fasten the receiver module as far from the control unit as
possible.
3. Route the antenna cable behind the driver side windshield pillar, above
the headliner and behind the rear view mirror.
4. Use the small mounting tabs to attach the antenna to the windshield,
behind the rear view mirror approximately 2" below the top of the
windshield. Attach verticaly for maximum performance.
Wireloom
1. Plug the wirelooms securely into the control unit and satellite relay
module.
2. Route wires from the control module and satellite relay module directly to
each connection point.
3. Separate the small and large RED, RED/WHITE, BLACK, TAN, VIOLET
and WHITE/GREEN wires.
4. Sleeve these wires with vinyl tubing or electrical tape and route them
through an existing rubber grommet into the engine compartment.
5. If an existing grommet is not available, drill a hole and install a snap
grommet.
7
AviStart 6500 Installation Manual